Corset Report

Corsets have been utilized by both men and women for 100's of years. The construction methods and shapes they produce have changed due to new technology similar to the changes in materials used. In order to reproduce the correct shapes, you need to have an understanding of the variety of items used in today's corsets.

Shaping the Body with Corsets

The oldest corsets are typically those with the least amount of curves. Your breast shape tends to be compressed and the subsequent reshaping of the breast mass gives a minimized appearance. To develop this shape you have to constrain and work against the typical shape and inherent curves of woman's body.

Corset Fabrication With Busks and Boning

The design of a corset is dependent on two underlying factors to be successful: a) the properties of the boning material, and b) the ability to tighten the lacing. In order for the corset to fit you comfortably you can only lace up and tighten so much, the remainder of the support is done by the boning.

A popular boning material is nylon coated spring steel that is usually a lighter color and is created in a group of lengths, thicknesses, and widths. When you are making a selection for the type of steel boning for a corset that will look like it was designed for you the width is of minor concern while your primary focus should be on the thickness. The steel boning characteristic makes a perfect corset because it is clearly flexible but is is extremely difficult to bend.

There are also busks which open and are used in the front of corsets to enable you to get into and out of your corset without help. The busk type fasteners were invented around 1860 and allowed construction with straight busks, the modern spoon busk was developed approximately ten years later. These corsets call all be found in our online corset superstore.